ORP Display Update
This document gives installation instructions for a local ORP
display. |
05/10/2006
35,270 bytes |
FET Driver Replacement
This document gives advice on replacing FET driver ICs. As these
were originally soldered directly to the board, replacement can be
troublesome. |
22/09/2006
196,806 bytes |
Locating Output Stage
Faults
This document gives a step-by-step procedure for troubleshooting
corona cell drive faults. It should be read in conjunction with the
OzOne.1 User Manual. It includes typical values for coil winding
resistance which is the easiest field check available for these
units. |
20/09/2006
77,408 bytes |
Hardware / Firmware Update
This details the installation of hardware and firmware updates to
all OzOne.1 units. The update includes additional features such as
switched high / low ozone rates and support for ORP feedback
control. It provides improved timing algorithms and implements
support for various hardware monitoring facilities built into the
original OzOne.1 machines. |
20/09/2006
236,102 bytes |
OzOne.1 User
Manual
This extensively updated documentation includes additional safety and
troubleshooting information. It supersedes the OzOne.1
Interim Documentation (below) and applies to S/N 5003-5005 as
well as 5001-5002 with OzOne.1 Retro Kit #1 installed. |
17/12/2005
1,039,128 bytes |
OzOne.1 Corona Cell Voltages
This document presents screen shots of corona cell waveforms. |
14/12/2005
67,528 bytes |
OzOne.1 Retro Kit #1 Notes
These notes describe modifications to bring S/N 5001-5002 up to S/N
5003-5005 level. As this kit includes safety modifications it is a
required update. |
09/12/2005
19,290 bytes |
OzOne.1 Interim Documentation
This documentation shipped originally as an interim release. It is
superseded by the OzOne.1 User Manual (above) which should now be be
used instead. It's available here for completeness only. |
02/12/2005
73,196 bytes |
